THE FABRICATION OF A SINGLE FACE PRESSURIZED KEROSENE COOKER

ABSTRACT

This project is concerned with the fabrication of as a single face pressurized kerosene cooker. The report shows the possible way in which the above mentioned can be designed, fabricated and maintained.

Its also shows the strength and properties of the materials it is made of.

Defects of the equipment can come through inability to maintain and inability to use well.

It can be due to irregular cleaning of pressurized parts, exposure to rain, moisture and sunlight as well as insufficient kerosene and air pressure in the tank before usage. Before fabricating, the properties of materials and kind of material involved are put into consideration.

The parts and its functions are described.

TABLE OF CONTENT

CHAPTER ONE

Introduction                                                               

CHAPTER TWO

Literature Review                                                                  

2.1       How the stove work                          

CHAPTER THREE

Design Analysis                                                                                 

CHAPTER FOUR

4.1       Material Selection                  

4.2       Component Parts       

4.3       Description of the component part                                                               

4.3       Constructional features of the stove

CHAPTER FIVE

5.1       Method of Operation                         

5.2       Maintenance                                                               

5.3       Capacity                                                                                 

5.4       Detection of kerosene shortage                                             

CHAPTER SIX

Cost Estimates                                                           

6.1       Material cost Analysis                        

6.2       Machine cost Analysis                                                           

6.3       Labour cost Analysis                         

CHAPTER SEVEN

7.1       Conclusion                                                     

7.2       recommendation                                            

 references                                                                              

CHAPTER ONE

INTRODUCTION

This project of fabrication of single face pressurized kerosene cooker is a copied design.

It is a manually operated type of stove, which has the capacity of supplying heat energy at high and low temperature. The type of stove so designed here do the industrial type with one burner.

Since the introduction of this pressurized kerosene cooker many effort has been made in order to enhance the ability to function well.

Thus we undertook this project design and fabrication of a single pressurized kerosene stove as a copped design from the popular Japan product (Regular Structural Stove) using locally available material of a 4mm (thickness) sheet metal.

Thus demonstrating the realization and importance of copy technology.

  TERMS AND CONDITIONS

Using our service is LEGAL and IS NOT prohibited by any university/college policies

You are allowed to use the original model papers you will receive in the following ways:

1. As a source for additional understanding of the subject

2. As a source for ideas for your own research (if properly referenced)

3. For PROPER paraphrasing (see your university definition of plagiarism and acceptable paraphrase)

4. Direct citing (if referenced properly)

Thank you so much for your respect to the authors copyright.

For more project materials

Log on to www.grossarchive.com

Or call

+2348130686500

+2348093423853