DESIGN AND CONSTRUCTION OF AUTOMATIC EMERGENCY LIGHT

  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0194
  • Access Fee: ₦5,000 ($14)
  • Chapters: 6 Chapters
  • Pages: 40 Pages
  • Methodology: Scientific
  • Reference: YES
  • Format: Microsoft Word
  • Views: 1.7K
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853
ABSTRACT
As the name of the project implies “Automatic Emergency Light” is an electronic system that can provide light during emergency situations i.e when mains (NEPA) supply fails.  This system can provide enough light with full brightness in a given room or office.  
The system makes use of white light emitting diodes for the lightings.  It is automatic in operation, in the sense that it can switch itself off when the battery charges full.
Automatic Emergency light comprises three sections: Rectifier section, charger section and the LED driver section.  The rectifier section comprises the step down transformer and the bridge  rectifier using four Diodes (IN4007x4), which converts the AC input to DC output (with some ac ripples).  This DC voltage is feed into the charger circuit after filtration.  The charger circuit is designed to charge the battery, which will power the LEDs when there is no mains supply.  The LEDs driver section consists a number of white LEDs connected in parallel, with 100n resistor in series with each.  The LEDs are built around a switching transistor.  This sections is the light section.
As said earlier, these LEDs give full liquid to the room or office when NEPA is off.
Automatic Emergency light system should not be confused or misunderstood with an inverter system.  The two are not the same.  An inverter converts a DC voltage to AC voltage but an Automatic Emergency light does not.  Also an invert is used to power other AC loads while this Automatic emergency light is used for lightings which make use of light emitting diodes only.  The efficiency of the Automatic emergency light system depends on the potential capacity of the battery.
With this system, when mains supply (NEPA) is off, the Electronics Engineers can say let there be light, and there will be light.


TABLE OF CONTENTS
Title Page i
Approval Page ii
Dedication iii
Acknowledgement iv
Abstract v
Table of Contents vii

CHAPTER ONE
1.0 Introduction 1
1.1 Aim 3
1.2 Scope of Study 3
1.3 Limitation 5

CHAPTER TWO
2.0 Literature Review 6
2.1 Component Used Discuss 7

CHAPTER THREE
3.0 System Operation 20
3.1 Block Diagram 20
3.2 Circuit Diagrams 24

CHAPTER FOUR
4.0 System Construction  and System Packaging 25
4.1 Prototyping 25
4.2 Component Mounting 25
4.3 Soldering 26
4.4 Testing 27
4.5 Packaging 28

CHAPTER FIVE
5.0 System Testing and Result 29
5.1 Continuity Testing 29
5.2 Voltage Testing 29
5.3 Result 30
5.4 BEME 31

CHAPTER SIX
6.0 Conclusion and Recommendation 33
6.1 Conclusion 33
6.2 Recommendation 33
References 35

DESIGN AND CONSTRUCTION OF AUTOMATIC EMERGENCY LIGHT
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0194
  • Access Fee: ₦5,000 ($14)
  • Chapters: 6 Chapters
  • Pages: 40 Pages
  • Methodology: Scientific
  • Reference: YES
  • Format: Microsoft Word
  • Views: 1.7K
Payment Instruction
Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
gtbank
Account Name Obiaks Business Venture
Account Number 0211074565

Bitcoin: Make a payment of 0.0005 to

Bitcoin(Btc)

btc wallet
Copy to clipboard Copy text

500
Leave a comment...

    Details

    Type Project
    Department Electrical Engineering
    Project ID ELE0194
    Fee ₦5,000 ($14)
    Chapters 6 Chapters
    No of Pages 40 Pages
    Methodology Scientific
    Reference YES
    Format Microsoft Word

    Related Works

    ABSTRACT This Project presents the design and construction of a microcontroller based Intelligent Emergency Light System. It is based on Hardwired control logic and micro programmed  control logic using a real time program known as Assembly language. This Project Intelligent Emergency Light will turn on the Emergency light only during the Dark... Continue Reading
    ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp section made by transistor, resistors, and the sensor LDR, changes controller which is made up of... Continue Reading
    ABSTRACT  The very fundamental reasons behind this project assignment is to expose student to the very important aspect of private and independent research work not only theories but also subsequent translation of the theoretical research work into a particular function system. The project construction of automatic fence light controller has been... Continue Reading
    ABSTRACT The very fundamental reasons behind this project assignment is to expose student to the very important aspect of private and independent research work not only theories but also subsequent translation of the theoretical research work into a particular function system. The project construction of automatic fence light controller has been... Continue Reading
    . ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp section made by... Continue Reading
    ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp, changes controller and battery of which the solar array is the most expensive. It is the solar... Continue Reading
    CHAPTER ONE INTRODUCTION 1.1Background Information Electricity is a general term comprising of a variety of phenomena resulting from the presence and flow of electric charge. These include many phenomena, such as lightning, static... Continue Reading
    CHAPTER ONE INTRODUCTION 1.1 Background Information Electricity is a general term comprising of a variety of phenomena resulting from the presence and flow of electric charge. These include many phenomena, such as lightning,... Continue Reading
    ABSTRACT The project “microcontroller based intelligent traffic light system with automatic street light and warning light” was designed to tackle the traffic issues in the country so as to establish automatic traffic control and monitoring system with near perfection. The project intelligent traffic light with automatic street light and... Continue Reading
    ABSTRACT The project “microcontroller based intelligent traffic light system with automatic street light and warning light” was designed to tackle the traffic issues in the country so as to establish automatic traffic control and monitoring system with near perfection.  The project intelligent traffic light with automatic street light and... Continue Reading
    Call Us
    whatsappWhatsApp Us