+234 813 0686 500
+234 809 3423 853
info@grossarchive.com

THE DESIGN AND CONSTRUCTION OF HOUSE BELL WITH INDICATING LIGHT

  • Type:Project
  • Pages:29
  • Format:Microsoft Word
(Electrical Engineering Project Topics & Materials)
 ABSTRACT
The design and construction of the House Bell with indicating light system was creative embarked on for the production of a better alarm signals. Meanwhile different measures and steps such as using electric bell, electric bulb, light emitting diode, 1 mm2 their cable, B Amps plug, lamp holder was used to achieve the objective. All the measures that were taken to ensure the functionality of this project were discussed in detail. 
Finally, conclusion and recommendation that will enable further quest and improvement in this project were carefully and creatively discussed.

 
TABLE OF CONTENTS 
Title Page
Approval Page 
Acknowledgement
Dedication 
Abstract 

CHAPTER ONE
INTRODUCTION 

CHAPTER TWO 
LITERATURE REVIEW 
Preamble
Essential Parts or Features of an Electric Ball
The Main Call Line
The sub – Call Line 

CHAPTER THREE 
MATERIALS AND METHODOLOGY    
Introduction
Materials 
The Wooden Board 
Switches
Lamp Holder
Cable 
Electric Bell 
Filament Lamp
Plug
Joint Box 
Wooden Block
Nails 
Screw Nail 
Clip 
Methodology
Mode of Connection and Construction

CHAPTER FOUR
PRINCIPLE OF OPERATION  
Schematic Diagram of an Electric Bell with Light Indictor
Mode of Operation

CHAPTER FIVE 
RESULT ANALYSIS AND DISCUSSION       
The Input Stage 
The Power Supply Stage 
Use and Economic Importance
Use of the Call System in Hotel Building

CHAPTER SIX 
CONCLUSION AND RECOMMENDATION
Problem Encountered
Conclusion      
Recommendation 

THE DESIGN AND CONSTRUCTION OF HOUSE BELL WITH INDICATING LIGHT

Share This

Details

Type Project
Department Electrical Engineering
Project ID ELE0143
Price ₦3,000 ($9)
No of Pages 29 Pages
Format Microsoft Word

500
Leave a comment...

    Details

    Type Project
    Department Electrical Engineering
    Project ID ELE0143
    Price ₦3,000 ($9)
    No of Pages 29 Pages
    Format Microsoft Word

    Related Works

    ABSTRACT The project “microcontroller based intelligent traffic light system with automatic street light and warning light” was designed to tackle the traffic issues in the country so as to establish automatic traffic control and monitoring system with near perfection. The project intelligent traffic light with automatic street light and... Continue Reading
    ABSTRACT The project “microcontroller based intelligent traffic light system with automatic street light and warning light” was designed to tackle the traffic issues in the country so as to establish automatic traffic control and monitoring system with near perfection. The project intelligent traffic light with automatic street light and... Continue Reading
    ABSTRACT As the name of the project implies “Automatic Emergency Light” is an electronic system that can provide light during emergency situations i.e when mains (NEPA) supply fails. This system can provide enough light with full brightness in a given room or office. The system makes use of white light emitting diodes for the lightings. It is... Continue Reading
    ABSTRACT The project work is on the design and construction of automatic two lane traffic light control. This system is based on digital electronics. It employs an astable multivibrator which is the clock generator that sends the clock into a time sequencing generator using a decade counter with ten (10) decodes output that has it’s binary... Continue Reading
    ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp section made by transistor, resistors, and the sensor LDR, changes controller which is made up of... Continue Reading
    ABSTRACT The very fundamental reasons behind this project assignment is to expose student to the very important aspect of private and independent research work not only theories but also subsequent translation of the theoretical research work into a particular function system. The project construction of automatic fence light controller has been... Continue Reading
    . ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp section made by... Continue Reading
    ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp, changes controller and battery of which the solar array is the most expensive. It is the solar... Continue Reading
    ABSTRACT For the fact that there are human activities and social functions that always take place within Enugu capital, there is need to establish a hospitality institutions, for instance Guest House. This project aims at proffering solution to the establishment of Guest House. In order to achieve this, some research work... Continue Reading
    CHAPTER ONE 1.1             INTRODUCTION The light sensitive alarm is an electronic circuit that detects a sudden shadow falling on the light sensor and sounds the bleeper. When this happens, the circuit will respond to gradual charges in brightness to avoid false alarm. The beeper sounds for only a short time to prevent the battery... Continue Reading