DESIGN OF MECHANICAL CONVERTABLE CREEPER

ABSTRACT This project is designed to determine households' access to domestic water supply via mechanical and  non-mechanical energy system in Usin, Ikole local government area Ekiti State Nigeria, in terms of  quality and quantity as the importance of adequate safe water supply to human health cannot be over  emphasized. However, safe/improve... Continue Reading

CHAPTER ONE INTRODUCTION In this pass, cutting of grasses in the school, track or filed, Industries hotel, public centers, Agriculture lands etc. was done by machete or cutlass. This method of manual cutting not only was laborious but also time consuming as it is human effort that is entirely needed both for cutting and motion. There was also... Continue Reading

It's a journal that explains the design of a shea butter plant.... Continue Reading

ABSTRACT The design of a 1000 tonnes per annum Shea butter plant was carried out using data obtained from literature. Assumptions were made, where experimental data were not available. The block diagram, process flow sheet, material and energy balance on the process was carried out and presented on this work. A total of six units were used in the... Continue Reading

PREFACE A new machine/equipment will provide satisfactory service if kept in proper operating condition. The inevitability of less than 100% reliability of any machine/equipment after some period and maintenance. Also in system of any complexity, certain replacement adjustments are... Continue Reading

ABSTRACT Mechanical Engineering Department of the Institute of Management and Technology has many non – functional machines. This is caused as a result of poor maintenance culture, which in turn resulted to breakdown of the Deep Freezer under review.... Continue Reading

REPAIR OF DEEP FREEZER ABSTRACT This work gives an account of all activities carried out to restore a faulty and abandoned deep freezer to normal functioning. This report therefore contains the different stages embarked in the execution of the project. These include the literature back ground, checking’s conducted, cleaning, repair operations... Continue Reading

ABSTRACT This project is concerned write the identification of those defects that are found in most of the drawing tables in the Mechanical Engineering drawing studio. The report investigates the possible ways through which the mentioned above can be brought back to normal standard for usage... Continue Reading

CHAPTER ONE 1.0 INTRODUCTION: 1.1 RESEARCH BACKGROUND: After harvest, agro raw materials are normally handled, transported, dried, stored and further processed into food, feed and fiber. In some basic post harvest activities, separation processes such as sorting, grading and cleaning are involved. In mechanized operations, these post harvest... Continue Reading

ABSTRACT In the mechanical engineering department of institute of management and technology there are many machines but it is not all that is functioning well. This may airless as a   result of lack of maintenance which is a prove in the breakdown of the air conditioner. The quality and effectiveness of materials were mated very well as referred... Continue Reading