ABSTRACT Voltage is a fundamental quantity that is important in every phase of electrical engineering from power system to voltage inside VLSI chips. Of The need to measure the output voltage of a supply is very important meanwhile, The voltmeter is an instrument for measuring... Continue Reading
TITTLE PAGE CONSTRUCTION AND DESIGN OF POLICE SIREN BY (NAME HERE) (MAT NO HERE) A PROJECT WORK SUBMITTED TO THE DEPARTMENT OF PHYSICS, FACULTY OF SCIENCE, MICHIGAN UNIVERSITY, NEW YORK. IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE AWARD OF B.Sc (HONS). DEGREE IN ELECTRONIC ENGINEERING (PHYSICS AND APPLIED ELECTRONICS ENGINEERING)... Continue Reading
ACKNOWLEDGEMENTS Thanks to God Almighty, the source and supplier of all potential, the father of all creation for the privilege to go through my first degree without Him, nothing would have been accomplished. My sincere and profound gratitude goes to my affectionate parent, Mr. & Mrs. Iserijeri and my siblings for their moral, spiritual and... Continue Reading
ABSTRACT This project is he design and construction of a voltage inverter system with trickle charging system. This device is design to provide power supply for the need of offices, household etc. In absence of NEPA power supply. It would also prevent harm to our appliances caused by power holding company LTD (NEPA) Random power outage . TABLE OF... Continue Reading
ABSTRACT The design of this 30 volt Audio Amplifier with volume, table and bass control which was done wit ht he combination of five (5) different circuit which are interconnected during or after construction. This amplifier operates with an option of a left and right channel. The combination of these circuit include this main amplifier circuit... Continue Reading
ABSTRACT The work presented in this thesis explored the potential of using a mix of renewable energy resources (hybrid power systems, HPSs) to generate electricity that meets power needs of mobile base stations at rural areas in Nigeria. The study was based on theoretical mathematical modeling and simulation using the hybrid optimization model for... Continue Reading
ABSTRACT Providing quality of service is a challenging issue in UMTS mobile networks for multimedia traffic (video, voice and data). Critical services such as real-time audio, voice and video are given priority over less critical ones, such as file transfer and web surfing. One of the approaches that efficiently provides standard quality of... Continue Reading
ABSTRACT Long term evolution (LTE) Network is often faced with the challenge of meeting up with the quality of service (QoS) requirement of the different services supported in the Network. Maintaining a trade-off between system throughput and fairness among users when making radio resources scheduling decisions is a very sensitive issue. Several... Continue Reading
ABSTRACT This work is concerned with the features, analysis and design of a stand-alone solar energy based power supply with maximum power point tracking (MPPT) scheme. The features and operations of various types of solar cells and panels and the performance characteristics under varying temperature and irradiance conditions are studied.... Continue Reading
Abstract This work investigates an improved protection solution based on the use of artificial neural network on the 330kV Nigerian Network modelled using Matlab R2014a. Measured fault voltages and currents signals decomposed using the discrete Fourier transform implemented via fast Fourier transform are fed as inputs to the neural network. The... Continue Reading
ABSTRACT A power system is set up basically to meet the demands of the customers. However, interruptions which are largely unavoidable contribute to the unavailability of power and thus prevent power system from achieving this. In most cases, it is the sustained interruptions that greatly affect both the utility company and its customers. Hence,... Continue Reading
ABSTRACT The importance of power supply to any economy cannot be overemphasized. It the pivot on which the economic, industrial and technological development of any nation is hinged upon. This study was carried out to assess the state of power supply and use in Gyel District of Jos- South Local Government Area of Plateau State. Four communities... Continue Reading
ABSTRACT As a result of recent increases in demand for electric power, utility transmission systems have been forced to operate under stressful conditions, often close to instability limits. Efforts to construct new transmission lines or enlarge networks are limited due to economic and environmental constraints. According to U.S. Department of... Continue Reading
ABSTRACT This project proposes a new type of voltage regulator based on single-phase converter otherwise known as transformerless AVR that compensates wide range voltage variations. This is not only capable of compensating variations at a much higher bandwidth but also does not experience mechanical wear down and is cost effective. The proposed... Continue Reading
ABSTRACT Nigeria is a country with a population of over 170 million; it is rightly the most populous country in Africa and the eighth most populous country in the world. According to the United Nations, one in six Africans is Nigerian. It is a regional power, listed among the “Next Eleven” economies, and a member of the Commonwealth of... Continue Reading
CHAPTER ONE INTRODUCTION 1.1 Background of the Study Inductive power transmission has become a more and more popular method to deliver power to mobile electronic devices and small appliances with a power consumption of up to 100W [1]. In its large meaning, inductive power transfer can take the form of electricity, light, heat or even sound and... Continue Reading
ABSTRACT The purpose of this project is to design and construction of a central wireless switch for electrical and electronic appliances. A central wireless switch for electrical and electronic appliance is a GSM based online power control switch system that controls the entire appliance in the EEE general office using GSM network. It will act as... Continue Reading
ABSTRACT This project work-up deals on the design and construction of a single phase step down nations fermor, with raking IKVA, 240V/11OV, 80V 12U, 6V. It is a multi-circuit transformer that has one input as the primary and tappins to produce the output (secondary). It is considered as a single coil in series with the supply and a common coil to... Continue Reading
ABSTRACT: This project deals with the design and implementation of a radio controlled car lock with 5-minutes ignition deactivation facility capable of locking a vehicle using a remote control from a distance. The system is designed in two functional units; the transmitter which is an RF handheld remote control, and the receiver units. The... Continue Reading
ABSTRACT The problem of Electricity are enormous and can never be treated completely until the fault department (maintenance) are improved upon for urgent and rapid response to line faults. The present protection scheme only isolates the lines in the event of faults, define the fault, but leaves no proper information about the location of the... Continue Reading
ABSTRACT Availability of electric power has been the most powerful vehicle for facilitating economic, industrial and social developments of any nation. Electric power is transmitted by means of transmission lines which deliver bulk power from generating stations to load centres and consumers. For electric power to get to the final consumers in... Continue Reading
ABSTRACT This project work deals on the design and construction of an automatic power changeover that will change/transfer control from MAINS to Gen set and can switch ON/OFF the Gen automatically. The system integrates phase selector in MAINS and changeover to Gen. It is designed in several blocks all combined to from one functional unit. A +5v... Continue Reading
CHAPTER ONE 1.0. INTRODUCTION 1.1. GENERAL DESCRIPTION OF THE PROJECT Industrial electronics has turned the whole world into a global village. One of the most indispensable aspects of these phenomena is automation, which forms the nucleus of the present day electronics technology. Considering the milestone, it was desired to make the... Continue Reading
CHAPTER ONE INTRODUCTION 1.1. Background of the Study The industrial Electronics has changed the whole field of Engineering and technology is occurring so rapidly, even in developing countries. It is so because newer technologies overcome older ones. After the industrial revolution the world shifted towards the information... Continue Reading
ABSTRACT This report is on stability study in electrical power system. The ability of an electric power system to reestablish the initial state (or one practically identical) after any disturbance manifested as a deviation from the initial parameter values for the system’s operation. The electric power sources in a power system are usually... Continue Reading