DESIGN AND CONSTRUCTION OF PUBLIC ADDRESS SYSTEM

  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0475
  • Access Fee: ₦5,000 ($14)
  • Pages: 37 Pages
  • Format: Microsoft Word
  • Views: 721
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853
INTRODUCTION
A public address system is an electronics sound amplification and distribution system with a microphone, amplifier and loud speaker used to allow a person to address a large public. The public address system consists of three main parts namely, the microphone (input transducer), amplifier and the loudspeaker (output transducer).
The microphone picks up the sound and convert it to electronic signal in milivolts and this is fed to the amplifier for amplification. In this project, a dual operational amplifier (OP-Amp) 1458 IC is used for the amplifications. The amplifier has two sections; the Pre-Amp and the power –AM. The pre-amp does the first boosting of the input audio signal to a level handleable by the last stage of the amplifier called power amp. This early stage (pre-amp) is designed to give good voltage gain. Hence the pre-amp is referred to as the voltage amplifier. The last amplifier stage is the power amp and is the stage that typically requires most attention; the power efficiency.
After the amplifier stage, the very small input signal is then magnified to a larger version and is fed to the speaker for conversion to sound. The speaker is an electromagnetic device that operates on the principle of electromagnetic induction and with the help of its component converts electrical signal to sound.

TABLE OF CONTENTS
TITLE PAGEi
APPROVAL PAGEii
DEDICATIONiii
ACKNOWLEDGEMENTiv

CHAPTER ONE
1.0BACKGROUND STUDY/INTRODUCTION1
1.1 AIMS AND OBJECTIVES OF STUDY 3
1.2SIGNIFICANT OF STUDY4
1.3SCOPE OF STUDY5

CHAPTER TWO
2.0LITERATURE REVIEW7
2.1RESISTORS 7
2.2CAPACITORS9
2.3TRANSFORMER12
2.4OPERATIONAL AMPLIFIER16
2.5MICROPHONE17
2.6PRE-AMP20
2.7POWER-AMP21

CHAPTER THREE
3.0SYSTEM OPERATION22
3.1CIRCUIT DIAGRAM22
3.2BLOCK DIAGRAM23
3.3OPERATION PRINCIPLE23

CHAPTER FOUR
4.0SYSTEM CONSTRUCTION AND PACKAGING24
4.1PHOTOTYPING24
4.2COMPONENT MOUNTING25
4.3SOLDERING26
4.4TESTING27

CHAPTER FIVE
5.0SYSTEM TESTING 28
5.1CONTINUITY TESTING28
5.2VOLTAGE TESTING29
5.3TESTING WITH OSCILLOSCOPE29

CHAPTER SIX
6.0CONCLUSION AND RECOMMENDATION31
6.1CONCLUSION31
6.2RECOMMENDATION32
REFERENCE36
DESIGN AND CONSTRUCTION OF PUBLIC ADDRESS SYSTEM
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0475
  • Access Fee: ₦5,000 ($14)
  • Pages: 37 Pages
  • Format: Microsoft Word
  • Views: 721
Payment Instruction
Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
gtbank
Account Name Obiaks Business Venture
Account Number 0211074565

Bitcoin: Make a payment of 0.0005 to

Bitcoin(Btc)

btc wallet
Copy to clipboard Copy text

Details

Type Project
Department Electrical Engineering
Project ID ELE0475
Fee ₦5,000 ($14)
No of Pages 37 Pages
Format Microsoft Word

Related Works

ABSTRACT It has become inevitable that there would be communication and due to the inherent limitation of the human voice, the public address system came to being. A public addressP.A SYSTEMor ”“ is an electronic amplific ,amplifier and loudspeakers, used to reinforce a given... Continue Reading
ABSTRACT It has become inevitable that there would be communication and due to the inherent limitation of the human voice, the public address system came to being. A public addressP.A SYSTEMor ”“ is an electronic amplific ,amplifier and loudspeakers, used to reinforce a given... Continue Reading
ABSTRACT It has become inevitable that there would be communication and due to the inherent limitation of the human voice, the public address system came to being. A public address or “P.A SYSTEM” is an electronic amplification system with a mixer ,amplifier and loudspeakers, used to reinforce a given sound , e.g a person making a speech,... Continue Reading
ABSTRACT It has become inevitable that there would be communication and due to the inherent limitation of the human voice, the public address system came to being. A public address or “P.A SYSTEM” is an electronic amplification system with a mixer  ,amplifier and loudspeakers, used to reinforce a given sound , e.g a person making a speech,... Continue Reading
ABSTRACT It has become inevitable that there would be communication and due to the inherent limitation of the human voice, the public address system came to being. A public address or “P.A SYSTEM” is an electronic amplification system with a mixer ,amplifier and loudspeakers, used to reinforce a given sound , e.g a person making a speech,... Continue Reading
ABSTRACT The growing expenses associated with education are often a catalyst for rising tuition and fees, and they play a large role as educators plan for the future of their institutions. The escalation of school fees at secondary level has been the immediate consequence of measures to be taken to reduce cost of education in Kenya. This study... Continue Reading
ABSTRACT This project is he design and construction of a voltage inverter system with trickle charging system. This device is design to provide power supply for the need of offices, household etc. In absence of NEPA power supply. It would also prevent harm to our appliances caused by power holding company LTD (NEPA) Random power outage . TABLE OF... Continue Reading
ABSTRACT This project is he design and construction of a voltage inverter system with trickle charging system. This device is design to provide power supply for the need of offices, household etc. In absence of NEPA power supply. It would also prevent harm to our appliances caused by power holding company LTD (NEPA) Random power outage . TABLE OF... Continue Reading
ABSTRACT This project is he design and construction of a voltage inverter system with trickle charging system. This device is design to provide power supply for the need of offices, household etc. In absence of NEPA power supply. It would also prevent harm to our appliances caused by power holding company LTD (NEPA) Random power outage . TABLE OF... Continue Reading
This project is about the Design and Construction of a Vehicle Tracking and  Accident Alert System (VTAA) using GPS and GSM Technology. It comprises of  integration between GPS receiver, microcontroller and GSM module, and of  course the push button for accident alert activation. The combination of all this  technology will produce our VTAA... Continue Reading
Call Us
whatsappWhatsApp Us