# ANALYSIS OF POWER QUALITY PROBLEMS IN SOLAR POWER DISTRIBUTION SYSTEM

• Type: Project
• Department: Electrical Engineering
• Project ID: ELE0436
• Access Fee: ₦5,000 (\$14)
• Pages: 31 Pages
• Format: Microsoft Word
• Views: 382

+234 8130 686 500
or
+234 8093 423 853

DECLARATION    i
DEDICATION    ii
ACKNOWLEDGEMENTS    iv
ABSTRACT    v
LIST OF TABLES    vii
LIST OF FIGURES    viii
LIST OF ACCRONYMS AND ABBREVIATIONS    ix
OPERATIONAL DEFINITION OF TERMS    x

INTRODUCTION    1
1.0 Background of the Study    1
1.2 Solar Power System    2
1.3 Operating Principle of the DSTATCOM    3
1.4. Modelling of PV Array    5
1.5 Modelling of DSTATCOM    6
1.6  Simulation Results    8
1.7 Voltage Sag (Without DSTATCOM)    10
1.8 Voltage Sag (With DSTATCOM)    11
1.9. Voltage Swell (without DSTATCOM)    12
1.10. Voltage Swell (with DSTATCOM)    13
1.11. Parameters of DSTATCOM    14
1.12. Parameters of Power Systems    15
1.13.Conclusions    16
REFERENCES    17

LIST OF TABLES

Table 1.1 Parameters of DSTATCOM……………………………….…………………………14
Table 2.2 Parameters of Power System…………………………………………………………15

LIST OF FIGURES
Figure.1.1  solar power system……………………………………………………………………2
Figure.1.2. Block Diagram of the voltage source converter based DSTATCOM………………...4
Figure.1.3. Equivalent circuit of a PV cell………………………………………………………...5
Figure.1.4.Calculation for DSTATCOM voltage injection……………………………………….7
Figure.1.7. Voltage Sag Without DSTATCOM………………………………………………....11
Figure.1.8. Voltage Sag With DSTATCOM…………………………………………………….12
Figure.1.9 Voltage Swell Without DSTATCOM………………………………………………..13
Figure.1.0. Voltage Swell Without DSTATCOM…………………………………………….....14

LIST OF ACCRONYMS AND ABBREVIATIONS
PV- photovoltaic
VSC- Voltage Source Converter
VSI- Voltage Source inverter
IGBT- insulated-gate bipolar transistor
PI- proportional integral
PWM- Pulse Width Modulation
KV- Kilo Volts
DSTATCOM- Distributed Static Compensator

ANALYSIS OF POWER QUALITY PROBLEMS IN SOLAR POWER DISTRIBUTION SYSTEM
+234 8130 686 500
or
+234 8093 423 853

• Type: Project
• Department: Electrical Engineering
• Project ID: ELE0436
• Access Fee: ₦5,000 (\$14)
• Pages: 31 Pages
• Format: Microsoft Word
• Views: 382
Payment Instruction
##### Bank payment for Nigerians, Make a payment of ₦ 5,000 to

Bank GTBANK
Account Number 0211074565

### Bitcoin(Btc)

 Copy to clipboard Copy text

#### Details

 Type Project Department Electrical Engineering Project ID ELE0436 Fee ₦5,000 (\$14) No of Pages 31 Pages Format Microsoft Word

#### Related Works

L (A CASE STUDY OF COMPUTER SCIENCE ND SOFTWARE LAB) CHAPTER ONE INTRODUCTION 1.1   BACKGROUND TO THE STUDY The use of renewable energy increased greatly just after the first big oil crisis in the late seventies. At that time, economic issues were the most important... Continue Reading
Abstract Electronic devices comprising of non-linear components (diodes, transistors, transformers, etc.) produce some number of harmonics in our power systems creating various voltage distortions [7]. As a result, several technical problems may arise for the device such as overheating and damage to sensitive equipment which would most likely lead... Continue Reading
CHAPTER ONE INTRODUCTION The quest to satisfy our need for stable power supply in Nigeria has driven most Nigerians into an ardent search for alternative renewable power sources. One of such major renewable power source in use is solar energy, which is energy obtained from the radiation of the sun. To obtain electrical power from the sun, four key... Continue Reading
ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading
ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller.... Continue Reading
ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading
ABSTRACT Automatic gate is one of most usefully thing to use in companies, colonies, collages, homes, and schools. There is some type to operate a gate such as a sliding on screw or on rack and pinion, piston operated, rotary. Design is available for some type of operation and it is most costly also When installation and maintenance cost is not... Continue Reading
CHAPTER ONE GENERAL INTRODUCTION 1.1                      INTRODUCTION The importance of electricity in the higher institutions of learning cannot be overemphasized. However, Electrical Power Generation in many universities in Nigeria is self generated by the institutions as the... Continue Reading
ABSTRACT The basic idea deals with detecting the voltage collapse ahead of time to provide the operators a lead time for remedial actions and for possible prevention of blackouts. To detect cases of voltage collapse, pattern recognition in conjunction with power system simulator for engineering (PSSE) program was created and then deployed in... Continue Reading
ABSTRACT  The basic idea deals with detecting the voltage collapse ahead of time to provide  the operators a lead time for remedial actions and for possible prevention of  blackouts. To detect cases of voltage collapse, pattern recognition in conjunction  with power system simulator for engineering (PSSE) program was created and then ... Continue Reading