ABSTRACT
This work provides a basic introduction on the use of computer in medical practice aimed at computerized patient care management system and its related processes at the Hansa clinic Enugu. It also identifies the procedure, process and tasks involved in the installing a computerized diagnostic system in the establishment which is operating a full manual system and the impact of such shift. The problem of efficiency, effectiveness and scientific methods of processing data in any organization is very important and the application of computer in the search for solution is very essential. A computerized medical diagnosis system which this project work addresses is made up of the software (intelligence) and hardware (computer) capable of carrying out diagnostic and prescription undertaking by the doctor for patient care. This is made possible by artificially impacting the knowledge of human expert (medical Doctor) to the system using specific logically related coding formats. This system just like the doctor takes a patient through series of questions and answer sessions during which it record the symptoms of a particular ailment. It can diagnose the disease and present prescriptions all with a view of presenting the patient with swift medical attention for quickest recovery possible.
TABLE OF CONTENTS
TITLE PAGE
CERTIFICATION PAGE
APPROVAL PAGE
DEDICATION
ACKNOWLEDGEMENT
ABSTRACT
ORGANIZATION OF WORK
TABLE OF CONTENT
CHAPTER ONE
1.0 INTRODUCTION
1.2 PROBLEM STATEMENT
1.3 AIMS/OBJECTIVES
1.4 PURPOSE OF STUDY
1.5 SIGNIFICANCE OF THE STUDY
1.6 SCOPE OF THE STUDY
1.7 CONSTRAINTS/LIMITATIONS
1.8 DEFINITION OF TERMS
CHAPTER TWO
2.0 REVIEW OF RELATED LITERATURE
CHAPTER THREE
3.0 DESCRIPTION AND ANALYSIS OF THE EXISTING SYSTEM
3.1 METHODOLOGY
3.2 GENERAL OVERVIEW OF SYSTEM
3.3 ORGANOGRAM
3.4 INFORMATION FLOW DIAGRAM
3.5 OUTPUT ANALYSIS
3.6 INPUT ANALYSIS
3.7 PROCESS
3.8 PROBLEMS OF THE EXISTING SYSTEM
3.9 JUSTIFICATION FOR THE NEW SYSTEM
CHAPTER FOUR
4.0 DESIGN AND IMPLEMENTATION
4.1 DESIGN STANDARD
4.2 OUTPUT SPECIFICATION AND DESIGN
4.3 INPUT SPECIFICATION AND DESIGN
4.4 FILE DESIGN
4.5 PROCEDURE CHART
4.6 SYSTEM FLOW CHART
4.7 IMPLEMENTATION
4.7.1 PROGRAM FLOW CHART
4.7.2 PSEUDO CODE
4.8 CODING
4.9 SYSTEM REQUIREMENTS
- SOFTWARE
- HARDWARE
- OPERATIONAL
- PERSONNEL
- ENVIRONMENT
4.10 TESTING
4.11 CUTOVER PROCESS
4.12 DOCUMENTATION
CHAPTER FIVE
5.0 SUMMARY, RECOMMENDATION AND CONCLUSION
5.1 SUMMARY
5.2 RECOMMENDATION
5.3 CONCLUSION
REFERENCES
BIBLIOGRAPHY
