ABSTRACT
This report aimed at determining the presence and removal of mercaptan sulphur in kerosene using colour indicator method. It is known that impurities such as free sulphur, sulphur dioxide, marketers, finding materials etc. are found in petroleum products. Consequently, absorbents like molecular sieve, calcium oxide and even activated carbon could be used to trap these impurities, thereby making the product impurity free.
The afficac of the absorption using calcium (Cao) Ercammerer flask was determined by titration. Excess Silver Nitrate is added to the sample ie effluent silves mercaptdes with his mercaptan sulphur compound present. The excess silver Nitrate is determined by titration with ammonium thiocrante using ferric ammonium sulphate indicator. Illustration graphically shows that the percentage of sulphur in the sam
ple reduces with increase in time. Furthermore, it was noted that slight increase in quantity of kerosene fields better result.
INTRODUCTION
Kerosene is a petroleum distillate having a flash point of 380c and density of 0.82ca and mainly used as an. Illuminant when burned and a wick as well as in cooking stove and as solvent in process industries. The sulphur content of illuminating oil varies greatly with the type of oil and the lese to which it is to be put into. In general, sulphur or content is important only when oil is to be burned under conditions where the sulphur dioxide that may evolve in the course of combustion must be limited or reduced. This could be found lamps and heating equipments. At maximum, the sulphur content specification for kerosene is 0.13%
Light odourless paraffin’s can be the primary product used specially as non- aromatic solvents. This apparently is extensively used in paint and gerosol industries. Consequently light odourless kerosene is also used in aviation turbines and jet fuel for air crafts. Jet fuel is simple kerosene which has been subjected to appropriate treatment to remove the impurities. Such impurities include mercaptans sulphur, hydrogen sulphide (H2S) gum etc. this impurities can be detected in the petroleum products using standard test methods which are extensive elaborated in this work and however removal of these impurities using chemical method. Some of the test methods include, colour indicate method, potentiomentric method mostly applied in kerosene aviation turbine and distillate fuels etc.
Among others in removal of these impurities mostly mercaptan sulphur in kerosene the following regents in colour indicator method are used. Then included silver Nitrate (A2N03) 0.LN, Ammonium thiocerante (NH4 CNS) 0.025N ferric Ammonium sulphate indicator (ALUM) etc
TABLE OF CONTENTS
Cover page
Title page
Approval page
Letter of Transmittal
Dedication
Acknowledgement
Abstract
CHAPTER ONE
Introduction
CHAPTER TWO
Literature review
CHAPTER THREE
Experimental procedure
CHAPTER FOUR
Experimental result
Data analysis
CHAPTER FIVE
Discussion
Conclusion
