Most Read Electrical Engineering Project Topics and Materials (Page 12)

Showing 276 - 300 of 530

276) DESIGN AND CONSTRUCTION OF A COMPUTER BASED CONTROL OF ELECTRICAL APPLIANCES

INTRODUCTION This project presents the design and construction of a computer based program used to control office appliance. It is based on a Graphic user interface (GUI) programming language (Visual Basic 6.0), Parallel Port Interactive Mode, Opto-Coupler Isolation of the computer from the appliance to prevent damage to the system should a fault... Continue Reading

277) CONSTRUCTION OF RADIO FREQUENCY GSM SIGNAL JAMMER

Abstract A wireless signal jammer is a device which blocks transmission by creating interference. This wireless signal jammer can be categorized into the Radio Frequency (RF) jammer and GSM jammer. A Radio Frequency jammer is a device used to disrupt or prevent communication via a broadcasted RF signal. It is an RF and GSM frequency disrupter... Continue Reading

278) CONSTRUCTION OF A BATTERY CHANGER USING SILICON CONTROLLED REGULATOR (SCR)

ABSTRACT The practical importance of a battery charger in today world cannot be over emphasized. This is so as those batteries accumulators are immensely needed by out auto mobile and in science laboratories. This thesis describes the methodical approach to the design and construction of any battery charger. However the procedure fro developed... Continue Reading

279) INTEGRATION OF DISTRIBUTED GENERATION (DG) OF ELECTRIC POWER SUPPLY

Adding to the requirement and need for power supply for day to day activities, it is therefore a necessity to design the power system to maintain minimal technical losses in the network, because most of our system component lack sufficient reactive power ability, this mean that the penetration of distributed generation (DG) will give way to reduce... Continue Reading
  • Type:Project
  • ID:ELE0190
  • Pages:108

280) WASTES AND SEWAGE AS A SOURCE OF ELECTRICITY GENERATION

ABSTRACT Waste and residuals are undeniably part of the human society. The accumulation of these materials and the “throw away” philosophy results in many environmental and health issues and safety hazard problems prevent sustainable development in terms of resource recovery and recycling of waste materials. The carbon sources in the waste can... Continue Reading

281) CONSTRUCTION OF 150 WATTS 162 AUDIO LOUDSPEAKER

ABSTRACT Audio loudspeaker (output transducer) is on of the most essential and powerful device used in telecommunication system. This is device capable of converting electrical signal into sound and vice versa. It is made up of few time of non-magnetic wire wound on a light cylindrical former that is mounted so that it can move freely insides the... Continue Reading

282) PATIENT HEARTBEAT AND TEMPERATURE MONITOR

Abstract Heart beat rate means the number of heartbeats per unit time, usually expressed as beats per minute (bpm). The human heart pounds to pump oxygen rich blood to the muscles and carry cell waste products away from the tissues. Heartbeat rate can vary according to the demand of the muscles to absorb oxygen and excrete carbon dioxide changes... Continue Reading

283) CONSTRUCTION AND IMPLEMENTATION OF 6V ECHARGEABLE LAMP

ABSTRACT Researchable lamp is a source of light that is generated from a D.C sources of supply this D.C sources is a battery that can also way be charged when it current and voltage ruse I decided to work on this as my project because its importance. It is very portable and help the a lot during night reading It also serves as an immanency sources... Continue Reading

284) DESIGN AND DEVELOPMENT OF COMPUTER BASED TEST SYSTEM TO FACILITATE E-EXAM.

ABSTRACT The purpose of this project was to design and develop a Computer Based Testing (CBT) system in order to facilitate the process of conducting e-examinations especially in tertiary institutions. There is a growing need to find an easy and effective way to carryout continuous assessments for the increasing population of students. The CBT... Continue Reading

285) DESIGN AND CONSTRUCTION OF 2KVA INVERTER

ABSTRACT This project presents the design and construction of a DC to AC inverter system. It is designed to meet up with the power demand in the offices/homes in the absence of power supply from National Supply Authority.  It is designed in such a way that it will take up to 12V DC from battery and inverts it to an output of 220V, 50Hz AC. It... Continue Reading

286) A FAULT DETECTION AND PROTECTION SCHEME FOR A 200 MVA TRANSFORMER USING FUZZY LOGIC

ABSTRACT Condition monitoring of Electrical power equipment has attracted considerable attention for years. The aim of this work is to use Fuzzy logic (FL) Tool Box in building a simulation system that will diagnose all kinds of incipient faults, phase to phase fault and overloading in a transformer and monitor its conditions. Current and rate of... Continue Reading

287) MODELING MODELINGAND PARAMETER EXTRACTION OF A AND PARAMETER EXTRACTION OF A 214 MVA TURBO- 214 MVA TURBO-GENERATOR DRIVEN BY DC GENERATOR DRIVEN BY DC MOTORS DURING OFF- MOTORS DURING OFF-LI

Abstract This thesis aims to extract d-axis machine parameters of a 214 MVA high-speed turbogenerator using well-established offline techniques. MATLAB/SIMULINK tool has been utilized to model the generator and perform sudden short-circuit (SSC) tests. Because constant speed operation of the generator is vital consideration for the accuracy of SSC... Continue Reading

288) ANALYSIS OF OPTIMUM ECONOMIC LOADING IN AN ELECTRICAL POWER SYSTEM

ABSTRACT Electricity companies typically possess numerous units and they need to commit unit because electricity cannot be stored in a large-scale system and demand is a random variable process fluctuating with the time of the day and the day of the week. A problem that must be frequently resolved by electricity utility is to economically... Continue Reading

289) EXERGY ANALYSIS OF COMBINED CYCLE POWER PLANT (GARRI”2” 180 MW)

ABSTRACT In recent years the entire world is a warring about energy resources limitation, specifically Sudan country confronts critical crises in fossil fuel resources and yet more of electricity energy producing from fired thermal power plants. One from these plants Garri”2” combined cycle producing about 180MW. Exergy analysis in the light... Continue Reading

290) THE DESIGN AND CONSTRUCTION OF AN INVERTER

TABLE OF CONTENTS Title Page Certification Page Acknowledgements Dedication  CHAPTER ONE:INTRODUCTION  1.1Definition of Term  CHAPTER TWO:TRANSFORMER FUNDAMENTALS   CHAPTER THREE:DESCRIPTION OF COMPONENTS  3.1Resistors  3.2Capacitors 3.2.1Types of Capacitor 3.3Semi-Conductor Diode  3.4Transistors  3.4.1Bipolar Transistor  3.5Field Effect... Continue Reading

291) DESIGN OF AN ELECTRONIC SIREN CIRCUIT

Siren is a device that produces loud noise. They are the means communication. Sirens  can be seen in emergency vehicles such as police cars, ambulances and fire trucks. Generally, sirens are used as indication or warning. There are different circuits to  produce different sirens.  The word siren first originated in Greek mythology and was also... Continue Reading

292) DESIGN AND IMPLEMENTATION OF INDUSTRIAL POWER CONTROL BY INTEGRAL CYCLE SWITCHING WITHOUT GENERATING HARMONIC (CASE STUDY: KAKIRA SUGAR WORKS)

TABLE OF CONTENTS Declaration....................................................................................................................................... i Approval .......................................................................................................................................... i... Continue Reading

293) MODELLING AND SIMULATION OF LEAKAGE-INDUCED PRESSURE DROPS ALONG OIL AND GAS PIPELINES

ABSTRACT This research work on “Modelling and Simulation of Leakage-Induced Pressure drops along oil and gas pipelines tends to develop flow equations that can detect and localize leakages in oil and gas pipelines by modifying the Darcy-weisbach equation for liquid/oil flow, and the Panhandle B equation for natural gas flow in pipelines. These... Continue Reading
  • Type:Project
  • ID:ELE0298
  • Pages:135

294) DESIGN AND CONSTRUCTION OF 36W AUTOMATIC SOLAR STREET LIGHT USING SOLAR PANEL, CHARGE CONTROLLER, LED AND WITH BATTERY

CHAPTER ONE INTRODUCTION 1.1Background Information Electricity is a general term comprising of a variety of phenomena resulting from the presence and flow of electric charge. These include many phenomena, such as lightning, static... Continue Reading

295) DESIGN AND CONSTRUCTION OF A POWER INVERTER

ABSTRACT Power inverter is an electrical appliance that can be used with DC battery as an alternativesource of energy supply in the event of power failures and energy crisis. It is cheap, clean,very conducive and silent when in operation and a very reliable source of power supply as togenerator. Modern research and technologies have shown that... Continue Reading

296) DESIGN AND CONSTRUCTION OF ELECTRICAL CODED DOOR LOCK SYSTEM

ABSTRACT Whenever we think of redefined security, we think of coded electrical door lock. It is a microcontroller based security door lock that can be used in homes, offices, laboratories, etc. for more reliable and high fidelity door control system, powered by electrons panel or electromechanical panels. Due to high rate of insecurity, especially... Continue Reading

297) DESIGN AND CONSTRUCTION OF FIRE ALARM

ABSTRACT  This project the design an construction of fire alarm was carried out with deep intensive and extensive research work my aim and objective in the price of work is to produce a standard device or electronics that will inform the security about a fire outbreak in the company or house for a quick reaction/action. In this project I shade... Continue Reading

298) DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading

299) DESIGN & IMPLEMENTATION OF DOUBLE SENSOR AUTOMATIC DOOR LOCK SECURITY SYSTEM USING RASPBERRY PI FINAL YEAR PROJECT

ABSTRACT In this current situation, the degree of security is feeble. So there is a lot of robbery, theft going on in and around the world. So, people fear to keep any of their valuables in their homes. Henceforth, many people prefer to keep it in banks. However, in this insecure world even banks are not too safe enough to satisfy people needs. A... Continue Reading

300) SPEED CONTROL OF MARINE DIESEL ENGINE SELF-TUNING BASED ON FUZZY PID CONTROL AND GENETIC ALGORITHM PID

The mathematical model of diesel engine and its speed regulation system are presented and computer simulation is conducted in Matlab software. Simulation results verify that the proposed method improves the control accuracy of speed of diesel engine. A fuzzy PID hybrid controller and a Genetic Algorithm PID of parameter self-adjusting is put... Continue Reading
Need help with your Electrical Engineering Project Topic? Click here to request assistnce or reach us on + 234 813 0686 6500
whatsappWhatsApp Us