+234 813 0686 500
+234 809 3423 853
info@grossarchive.com

DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

  • Type:Project
  • Chapters:5
  • Pages:65
  • Format:Microsoft Word
(Economics Project Topics & Materials)

DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

ABSTRACT

The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective gadgets like cut out switches; to give the 200W expected. The solar panel was mounted outside the building to allow for maximum collection of sun energy. It is expected that the system will help the department meet up with its office duties even when central power is not available.

CHAPTER ONE
INTRODUCTION

1.1 NEED FOR THE PROJECT
The general objective of the system is to provide efficiency, steadiness in the use of power appliances, by ensuring continuous availability of power supply even in the absence of mains. Uninterruptability of the system made it possible to eliminate all suspense from mains outage during the execution of an important and urgent assignment as may be required.
For better production of the system, the system was operated at a fully charged condition of the battery.
The project was rated 200W of 220V and 50Hz. It was expected that at this condition, it was favourable to carry load of the stipulated power. Loads of low power factors are not helpful since they produce spikes. Overloading is not potent to provide zero change over time and the inverter had LEDs which indicates mains failure and battery discharge and system fault.
1.2 SCOPE OF STUDY
This solar power source makes it possible to provide a clean reliable supply of alternative electricity free of sags or surges which could be found in the line voltage frequency.
The solar power system (SPS) system achieved this by direct current from solar panel and by rectifying the standard main supply, using the direct current to charge the batteries and to provide clean alternative power by passing the energy a filter system.
It has zero change over time and LEDs which indicates mains fail and battery discharge level and it provides 100% protection against line noise, spikes surges and audio frequency interference.
1.3 DEFINITION OF TERMS
1. Inverter unit: This unit converts a DC voltage into AC voltage with the help of the inverter unit.
2. Automatic Control Unit: This provides all the required control needed to meet up the objective of the whole system
3. Battery Unit: This is a secondary cell unit, capable of storing enough DC voltage from either sun or AC main, of which is later converted to AC voltage.

Share This

Details

Type Project
Department Economics
Project ID ECO0290
Price ₦3,000 ($9)
Chapters 5 Chapters
No of Pages 65 Pages
Format Microsoft Word

500
Leave a comment...

    Details

    Type Project
    Department Economics
    Project ID ECO0290
    Price ₦3,000 ($9)
    Chapters 5 Chapters
    No of Pages 65 Pages
    Format Microsoft Word

    Related Works

    L (A CASE STUDY OF COMPUTER SCIENCE ND SOFTWARE LAB) CHAPTER ONE INTRODUCTION 1.1   BACKGROUND TO THE STUDY The use of renewable energy increased greatly just after the first big oil crisis in the late seventies. At that time, economic issues were the most important... Continue Reading
    THE DESIGN AND CONSTRUCTION OF MINI RADIO BROADCAST TRANSMITTERAND AUDIO CONSOLE USING FREQUENCYMODULATION (FM) WITH POWER RATING OF 1 WATT ABSTRACT The early transmitter for radio broadcasting is so big and bulky that they do occupy numerous spaces. The circuitries are mainly designed with valves, which are big in sizes. With the advent of... Continue Reading
    (A CASE STUDY OF COMPUTER SCIENCE LABORATORY) ABSTRACT This Project entitled “DESIGN AND IMPLEMENTATION OF SOLAR POWER BANK” was designed to expose the participants to the practical skills needed in designing a solar power bank. The specification of the solar system is: Solar Panel, Mounting... Continue Reading
    EFFECT OF FRAUD MANAGEMENT ON A SURVIVAL OF A COMPANY (A CASE STUDY OF FIRST BANK NIGERIA PLC, UGHELLI BRANCH) ABSTRACT This topic is on “Effect of Fraud Management on a Survival of a Company” with special reference to First Bank Nigeria Plc. Ughelli branch. Indeed, fraud which have been a feature of Nigeria society today has cause a lot of... Continue Reading
    CHAPTER ONE INTRODUCTION The quest to satisfy our need for stable power supply in Nigeria has driven most Nigerians into an ardent search for alternative renewable power sources. One of such major renewable power source in use is solar energy, which is energy obtained from the radiation of the sun. To obtain electrical power from the sun, four key... Continue Reading
    . ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp section made by... Continue Reading
    ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp, changes controller and battery of which the solar array is the most expensive. It is the solar... Continue Reading
    ABSTRACT This work is concerned with the features, analysis and design of a stand-alone solar energy based power supply with maximum power point tracking (MPPT) scheme. The features and operations of various types of solar cells and panels and the performance characteristics under varying temperature and irradiance conditions are studied.... Continue Reading
    CHAPTER ONE 1.0 INTRODUCTION This project gives the insight on the design and construction of a transmission power line vandalism detector system. Vandalism means destructive action. It is a hateful and deliberate defacement/destruction of somebody else’s property or national assets like thehigh-voltage transmission power lines, transmission... Continue Reading
      CHAPTER ONE 1.0 INTRODUCTION 1.1 BACKGROUND OF STUDY Safety is an essential component of transportation engineering. The safety of road transportation involves many factors including driver skills, roadway characteristics, vehicle conditions, and weather. In addition to crash causation, the identification of hazards that may increase severity... Continue Reading