TOPOGRAPHICAL SURVEYING OF GOVERNMENT TECHNICAL COLLAGE IDAH KOGI STATE

(Estate Management)
TOPOGRAPHICAL SURVEYING OF GOVERNMENT TECHNICAL COLLAGE IDAH
KOGI STATE.

ABSTRCT
This project aimed purposely at the production of topographic plan of Government technical college idah Kogi State. The following surveying methods are carried out to achieve this project. A reconnaissance surveying of the area to be survey was carried out before other topographical surveying method was carried out total station traversing for coordinating of the station was carried out leveling which is purposely aimed at determining the deference in spot height after which the topographical map was produced at the scale of 1:5,000, this plan would be immense value as would be suit for the designing and planning of the infrastructural developing of the study area such as roads, building a clear image of the surface of the ground, topographical. Conventionally should land configuration by means of contour lines.
TABLE OF CONTENT
CHAPTER ONE: INTRODUCTION
Aim Of The Study
Objective Of The Studies
Significant Of The Project
Limitation Of The Study
Scope Of The Study
Study Area
Date And Duration Of The Project
Project Order And Specification
Level Pf Participation
CHAPTER TWO: PROJECT PLANNING
2.1     Data Search
2.2    Instrument Test
2.3     Instrumentation
2.4    Temporary Adjustment
2.6    Field Reconnaissance
2.7    Verification of Controls (In Situ Check)
2.8    Computation of Data from Coordinate Values
2.9 Selection of Station
2.10    Documentation
2.11 Data Sources
2.12 Secondary Data Source
2.13     Primary Data Source
CHAPTER THREE: DATA ACQUISITION  
3.1 Spatial Data Acquisition
3.2 Total Station Traversing By Direct Coordination Technique.
3.3   Spot Heightening: The Procedures Were:
3.4    Detailing
CHAPTER FOUR: DATA PROCESSING
4.1    Forward Computation
4.2    Back Computation
4.3    Area Computation
4.4   Abstraction of Data
4.5     Analysis of Result
4.6.1   Analysis of Linear Errors
4.6.2     Analysis of Elevation Closure
4.6.3     Analysis of Linear Accuracy
4.7    Map Production
CHAPTER FIVE: PROBLEMS ENCOUNTERED, PRECAULTION TAKEN RECOMMENDATION AND CONCLUSION
5.1    Problem Encountered
5.2    Precaution Taken
5.3    Recommendation
5.4    Conclusion
    References
    Appendices
CHAPTER ONE
INTRODUCTION
The origin of topography comes from “topo” for “place” and graphic for “writing” its closely related to geology and surveying which are concerned with accurately the land surface. And it’s also closely tied to geography and mapping system the GIS,
Evaluation is the distinguishing factor for topography maps. In GIS, we use digital elevation model for terrain. Ten out of ten topography maps shows contour lines which are just lines of equal elevation. The narrow definition of topography is specific to the arrangement of land forms.
But in a loader sense, it incorporates natural and artificial features. For example:
Topography maps often tie in administrative boundaries, cities, hydrographic parks, transportation and buildings, contour lines (Iso-lines) connect points of equal elevation by reading contours. We interpret height slope and shape in topography maps.
If contours are close together the slop is steep. But when contours are spread apart the slope is more gradual. We use contours for mountains valleys and bathymetry. For example, Mount Fuji stands at 3,776 meter spacing each contour lines represents equal elevations. Almost at the place of mountain Fuji. It is a 3750 meter contour line.
There is no “World Authority” in topography mapping instead each country set their mapping agency designs their own topography maps with a specific goal in mind. For example constructing a meal high way might drive a topographic ma to feature wood land cover, soil types or rock classification along the route, overtime topographic map series often het periodic updates, but the true is that they can be complex and take years to create. In the United States, the first USGS topographic map was surveyed in 1892. Since then, map revision have continued for over 125+ years. The USGS procedure topo maps at 1:250,000, 1:100,000, 1:63, 360, 000 and 1:24,000. The most common is the 7:5 minute quadrangle series where one inch in the map representing 24,000 inches on the ground.
Another good example of topographic map is the USGS topes fug of time and terrain this colorful map, its overlays topography (hill shade) with understanding rock formations. This helps unravel the geologic history of the continent such as mountain building events.
Topography Application and Uses
Topography maps show how rivers flow, how high mountain rise and how steep valleys descend. They lay out the land such as in these examples.
Engineering use topographic maps to plan a road, construct a called tower or plan a hydro electric dam.
Geologist Use Topography to Understand telboric activity . Land forms and where to dig a mine
Hackers use topographic map to fund trials and steepness of slope to plan their ascent.
Astronomers study the topography outside earth like on the moon, mars or an as steroid climate scientist tie topography into climate models to recognize air and water-flow. As landscapes evolve and technology advances topographers face an uphill battle for accuracy and completeness
AIM OF THE STUDY
This study aims of carrying out a topographic survey of government technical college Idah Kogi State.
OBJECTIVE OF THE STUDIES
This study is out to archive the following objectives
Reconstitute a sight in synthesized image of the ground.
Determine of trajectory of over flight of the ground.
Calculate surface or volumes.
Trace topographic profile.
SIGNIFICANT OF THE PROJECT
Engineers need a topographical survey to see the surface of elevation of the land and whether dirt must be inserted or removed to adjust the property grade
Architect could use the survey for construction of 3D plot of their design this plot can be submitted before talking with decision makers for approval of a building site is transited by significant topographical challenges such as steep grades, existing main made structure’s or other problematic conditions a topographical inspection should be used to ensure that the design proposed will work under these conditions before construction start.
Government agencies also users topographical surveys to produce employment evaluate existing infrastmeture, carry out required revisions and consider environmental projects and emplace mat the construction and zooming regulation.  
LIMITATION OF THE STUDY
Time is a common basic for the land surveyor. But talking about time management or organization problem, instead the vast amount of time some owners hold there properties can precut challenge for the surveyor. In short, a property that has been in a family for generation has undergone change that are not reflected in the original deeds and streams change channels the physical evidence upholding the legal land transcoption has simply vanished into the most of time on top of vanished makers. Accommodation for neighbors and other understandings that were never formally documented can blur the property lines, sometimes catching the current owners ny surprise. Slope of land that have long been used by overcome around are found to be private property or a fence been placed along an uncovered boundary but never corrected new owner comes along and the first survey in decades highlights the surveyors applied as much art as science in defining the boundaries of mutigenerational properties
Weather and Seasonal Changes; weather and seasonal changes of the season present another challenge. The perfect environment for a survey is really to be found. Land surveyors could wish that all the tics were bare have this ground clear of leaves, with comfortable transperature and the night light you client often have this luxury. Bright sunlight creates deep shadow which masks features. They make surface wet and even when the rain stops water drop from the trees. The wind that comes with the rain is difficult to walk while carrying expensive equipment cold and freeze the surveyor and the lubrication required for the instruments to operate smoothly many of today’s electronics tools have don’t always match what mother nature makes available.
SCOPE OF THE STUDY
This study aim of carrying out topographical survey at Government Technical Collage Idah, Kogi State. However it out to achieve the following objectives reconstitute a sight synthesized image of the ground at the Government technical collage idah, Kogi state. Determine a trajectory of a flight of the ground at the government technical collage idah, kogi state. Calculate the surface area of government technical collage have the topographical profile of Government Technical Collage Idah, Kogi State.
STUDY AREA
The study area is Government Technical Collage Idah, Kogi State.
PROJECT ORDER AND SPECIFICATION
Field survey notes are the records of work done on the field. They contain the complete graphic table or winters (or combination thereof) survey records
LEVEL PF PARTICIPATION
This is the stage where I and the other member of the of the group planned on how the survey projects will be done and by sharing and showing everybody’s position and contribution to be made in the course of the project to selecting and testing instrument and other equipment to be used on the field during this projection down to the creation of works office recce.

TERMS AND CONDITIONS

Using our service is LEGAL and IS NOT prohibited by any university/college policies

You are allowed to use the original model papers you will receive in the following ways:

1. As a source for additional understanding of the subject

2. As a source for ideas for your own research (if properly referenced)

3. For PROPER paraphrasing ( see your university definition of plagiarism and acceptable paraphrase)

4. Direct citing ( if referenced properly)

Thank you so much for your respect to the authors copyright.


For more project materials

Log on to www.grossarchive.com

Or call

+2348130686500

+2348093423853

500
Leave a comment...