+234 813 0686 500
+234 809 3423 853
info@grossarchive.com

SYNTHESIS AND CHARACTERIZATION OF PYRIDYL BASED SCHIFF

  • Type:Project
  • Pages:46
  • Format:Microsoft Word
(Chemistry Project Topics & Materials)

Metal complexes are scientifically known to be active and effective as antibacterial, antivirus and some antifungal etc. This project work is targeted at preparing complex from transition metals say; cobalt, cupper, zinc and nickel and organic ligands synthesised from pyridyl based schiff bases, one from 2-aminopyridine and benzaldehyde and second from 2-aminopyridine and 2,4-dihydroxylbenzaldehyde. The analysis and completion is based on thin-layer chromatography, column-chromatography and IR-spectral analysis. 




TABLE OF CONTENT
Dedication…………………………………………………  i
Content………………………………………………………ii
Acknowledgement…………………………………………….iii
Abstract…………………………………………………………iv
List of figures……………………………………………………v
List of tables……………………………………………………..vi
List of equations…………………………………………………vii
List of tables…………………………………………………..    viii

CHAPTER ONE
LITERATURE REVIEW
Introduction
The chemistry of transition elements
Objectives of study
 Complexes of transition elements
why metal complexes are coluored
the nature of chemical bonding in transition metal complexes
Effect of the complex constituents
Effect of ligands
Effect of metal ion
The coordination chemistry of metal used (Nickel)
The chemistry of Schiff Base (Imine)
The Biological importance and activity of Schiff Base
Ligand studied
Pyridyl based Schiff Base
           1.10. Apllications and activities of Schiff base complexes

CHAPTER TWO
1.MATERIALS AND EQUIPMENT
2.1. REAGENTS
2.1.1. Ethanol
2.1.2. Benz aldehyde
2.1.3. 2, 4-dihydroxylbenzaldehyde
2.1.4. Methanol
2.1.5. Glacial acetic acid
2.1.6. Diethyl ether
2.1.7. n-hexane
2.1.8. 2-aminopyridine
2.1.9. Distilled Water
 2.10. Dichloromethan
2.11. Nickel metal salt
2.12. Terpene oil
2.13. Silica gel
2.2.EQUIPMENT
2.2.1. Reflux setup
2.2.2. Distillation setup
2.2.3. TLC plate and its materials
2.2.4. UV machine
2.2.5. Trituration setup
2.2.6. Column chromatography setup
2.2.7 Chemical Balance
2.3. EXPERIMENTAL TECHNIQUES AND PROCEDURES
2.3.1. General cleanupof glass wares and other apparatus
2.3.2. Distillation of Benz aldehyde
2.3.3. Refluxing to prepare our Schiff base in without catalyst
2.3.4. Refluxing to prepare our Schiff base with catalyst 
2.3.5. Concentration using rotary evaporator
2.3.6. Running of TLC check
2.3.7. Trituration of Schiff base produce from 2, 4-dihydroxyl benzaldehyde with diethylether and methanol in different setup
2.3.8. Purification with column chromatography
2.3.9. Refluxing of the Schiff base with the metal salt (copper nitrate)
CHAPTER THREE
3.1 RESULTS
3.1.1. Melting point results
3.1.2. FTIR results and analysis
CHAPTER FOUR
4.1 Discussion of result
4.2 Conclusion 
4.3. References.
SYNTHESIS AND CHARACTERIZATION OF PYRIDYL BASED SCHIFF

Share This

Details

Type Project
Department Chemistry
Project ID CHM0058
Price ₦3,000 ($9)
No of Pages 46 Pages
Format Microsoft Word

500
Leave a comment...

    Details

    Type Project
    Department Chemistry
    Project ID CHM0058
    Price ₦3,000 ($9)
    No of Pages 46 Pages
    Format Microsoft Word

    Related Works

    SYNTHESIS AND 1 HNMR CHARACTERIZATION OF Co(II) AND Fe(II) COMPLEXES OF MIXED SCHIFF BASE LIGAND DERIVED FROM SALICYLALDEHYDE AND 2-HYDROXY-1-NAPHTHALDEHYDE WITH 2-AMINOPHENOL A RESEARCH PROJECT BY NKEMJIKA, EMMANUEL EKE 12/SC/CH/256 SUBMITTED TO DEPARTMENT OF CHEMISTRY FACULTY OF SCIENCE UNIVERSITY OF UYO, UYO AKWA IBOM STATE IN PARTIAL... Continue Reading
    SYNTHESIS AND 1 HNMR CHARACTERIZATION OF Co(II) AND Fe(II) COMPLEXES OF MIXED SCHIFF BASE LIGAND DERIVED FROM SALICYLALDEHYDE AND 2-HYDROXY-1-NAPHTHALDEHYDE WITH 2-AMINOPHENOL A RESEARCH PROJECT BY NKEMJIKA, EMMANUEL EKE 12/SC/CH/256 SUBMITTED TO DEPARTMENT OF CHEMISTRY FACULTY OF SCIENCE UNIVERSITY OF UYO, UYO AKWA IBOM STATE IN PARTIAL... Continue Reading
    Mechanochemical synthesis of [Cu(OOCCH3)2(THB)2] and theMechanochemical synthesis of [Cu(OOCCH3)2(THB)2] were carried out, and a brown solid complexes obtained in both experiment was washed in ethanol respectively. The physical and instrumental characterisation of the complexes carried out revealed that the complexes obtained are the same... Continue Reading
    ABSTRACT According to a few recent studies, calcium titanate is a material that is similar to hydroxyapatite in biological properties. However, calcium titanate is not currently being used in the biomedical application as to hydroxyapatite. The objective is to prepare nano calcium titanate powder from the solution of calcium oxide, ethanol, and... Continue Reading
    ABSTRACT The present paper describes the synthesis of Acid Orange(7)dye which can be used as dyes for cellulose acetate biopolymer. They were obtained by the diazotization of a monoazo component of the mono-azobenzene type, followed by coupling. The monoazo components were obtained by the diazotization of sulphanilic acid and coupling with... Continue Reading
    ABSTRACT The strategy of utilizing mechanochemical synthesis to obtain metal-organic frameworks with high surface area and nanodisperse particles has been espoused. Transition metal ions have been shown to form complexes with organic moieties such as benzyl-N,N-dimethyldithiocarbamate. It has been established that iron in its oxidised state (Fe 3+... Continue Reading
    ABSTRACT Nickel amine carboxylate complexes were synthesized by reacting Ni(ii)chloride with ammonia, malonic and tartaric acid, which formed Nickel amine malonate and Nickel amine tartarate of blue and green crystal and the percentage yield are of both complexes are 62.65% and 62.83% respectively. The decomposition temperatures were 218o C and... Continue Reading
    ABSTRACT This thesis aimed at the production of biolubricant from vegetable oils. The first stage produced methyl ester of the oil and in the second stage; the methyl ester was transesterified with Trimethylolpropane (TMP) in a ratio of 3.5:1 at 1500C to produce the biolubricant. The pour points biolubricant and its blend were significantly... Continue Reading
    ABSTRACT This project was carried out using coal sample from Onyeama coal mine Enugu, Enugu State. Activated coal was produced by carbonizing the coal and activating it using phosphoric acid at a temperature of 5500c. the degree of bleaching of raw palm oil was monitored using spectronic meter through... Continue Reading
    ABSTRACT This project was carried out using coal sample from Onyeama coal mine Enugu, Enugu State.Activated coal was produced by carbonizing the coal and activating it using phosphoric acid at a temperature of 5500c. the degree of bleaching of raw palm oil was monitored using spectronic meter through absorbance measurement. The essence was to... Continue Reading