The aim of this design work is to allow traffic light to rotate over a designated time interval between the two roads concerned i.e IMT and ESUT Junction. This design will control and monitor devices and cars within its environment i.e the junction.
It will as well steer small vehicles showing them how to obey the traffic instructions coming from the traffic signals. The system is designed to operate in a red time mode to monitor the volume of traffic light.
The project will determine whether any of the devices is defective and of the same time, send signals to indicate faulty devices. The software also includes the maintenance of these devices giving warning signs wherever a fault is detected.
The software is designed to detect the flow of traffic showing how and when vehicles will be passed or in order words, it is the aim of the project to solve problems as a result of manual and simulate the existing system into a new system.
TABLE OF CONTENTS
Title Page
Certification
Dedication
Acknowledgement
Abstract
Organization of the work
CHAPTER ONE
1.0Introduction
1.1Statement of problem
1.2Purpose of the study
1.3Aims and objectives
1.4Scope or Delimitations
1.5Limitations and constraints
1.6Assumptions
1.7Definition of terms
CHAPTER TWO
2.0Review of related literature
CHAPTER THREE
Description and analysis of the existing system
3.1Fact finding methods
3.2Organizational structure
3.3Objectives of the existing system
3.3Input, process, output analysis
3.4Input, process, output analysis
3.5Information flow diagram
3.6Problems of the existing system
3.6Justification of the new system
CHAPTER FOUR
Design of the new system
4.1Output specification and design
4.2Input specification and design
4.3File design
4.4Procedure chart
4.5System flowchart
4.6System requirement
CHAPTER FIVE
Implementation
5.1Program design
5.2Source program
5.3Program flowchart
5.4Pseudocades
5.5Test run
CHAPTER SIX
Documentation
6.1System documentation
6.2Program documentation
6.3User documentation
CHAPTER SEVEN
Conclusion and Recommendation
7.1Conclusion
7.2Recommendation
Bibliography
DESIGN AND SIMULATION OF TRAFFIC CONTROL SYSTEM FOR A T-JUNCTION A CASE STUDY OF ESUT-IMT ROAD JUNCTION
ABSTRACT The aim of this design work is to allow traffic light to rotate over a designated time interval between the two roads concerned i.e IMT and ESUT Junction. This design will control and monitor devices and cars within its environment i.e the junction. It will as well steer small vehicles showing them how to obey the traffic instructions... Continue Reading
ORGANIZATION OF WORK This project has seven chapters. Each chapter deals with the chapter one. This chapter introduces the statement of the problem purpose of this study. The aims and objectives of the program. The scope, limitations and constraints, assumptions of program, and the... Continue Reading
ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the... Continue Reading
ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the... Continue Reading
ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a... Continue Reading
ABSTRACT This project entitled “Rehabilitation of Road” is aimed at investigating the causes of failure on the road linking Federal Secretariat, IMT Civil soil lab to Industrial Centre IMT Campus III Enugu and the possible way of re-designing it for its effective use by IMT community and visitors of IMT. But before the road is being... Continue Reading
REHABILITATION OF ROAD LINKING UMUEKULUMMIRI STREET TO IMT AWARNESS GROUND JUNCTION IMT CAMPUS III ENUGU ABSTRACT This project entitled “Rehabilitation of Road” is aimed at investigating the causes of failure on the road linking Federal Secretariat, IMT Civil soil lab to Industrial Centre IMT Campus III Enugu and the possible way of... Continue Reading
ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a... Continue Reading
ABSTRACT The control of traffic at road junction, which was done purely by human effort, proves to be inefficient owing to the increasing rate of both motorists as well as the complexity of road networks. This inadequacy brought about the use of discrete solid-state electronics up to the usage of a computer controlled microprocessor, but the... Continue Reading
ABSTRACT This project is carried out in order to develop computer based Traffic Offence documentation system to all aviate the problems incurred in Federal Road softy commissioner problems such as Traffic offences, Mis-sorting of files, which may result when handling or processing these files manually. The project was done so as to develop a... Continue Reading